Assembly of the saw was straight forward with no real problems. Just the typical minor stuff you run into. Of course the pieces were much larger and heavier than anything I had done before!

One I had done most everything I decided to move the saw in place before putting on the table. It was hard enough to move as it was, once the table was on I knew I wouldn't be able to lift it with the engine lift. Even now with the wheels on it, it is difficult to move because it wants to lean over as you pick it up.

This is where is sits. Waiting on motor so I can finish it up. It still needs new tires installed and a few minor odds and ends. Like blades. But till I get 3 phase power, not sense in spending that money.